Process 600t/h lumpy iron ore Operating capacity of 600 800t/h Efficient separation at SGs as high as 41g/cm3 Dense Media Separation on Iron Ore Cut SG of 36 38 g/cm3 Not considered at 4g/cm3 Viscosity of FeSi Ferrosilicon Water atomised Gas atomised Maximiserecovery and yield Dense Media Separation on Iron Ore Dense Media Separation on Iron Ore
Magnetic Iron Ore ResourcesHistory of Development of Magnetic SeparatorTreatment Method DeterminationPresent Practice and State of DevelopmentWet Magnetic Separation of Cornwall OreResults of Dry Separation in Testing LaboratorySummaryA thorough examination of some of the iron-ore properties and the knowledge acquired by development of extensive underground workings makes it possible to make quite definite estimates of tonnage available in certain areas, which show very large reserves. F. S. Witherbee in his paper read before the American Iron and Steel Institute last October gave an estimate of 1,100,000,000 tons of crude magnetic ore above 30 p…
Jan 01, 2015· On the other hand, the magnetic products from the LIMS and SLon magnetic separators are fed to the secondary ball mill system, ground to about 80% -75 μm, and finally treated by drum LIMS and SLon magnetic separators for cleaning and scavenging to recover about 30% of the mass as the final iron ore concentrate, with about 15% of the mass discharged as the final tails. Because theCited by: 12
The successful development and application of big lump ore dry permanent magnetic separators and high-efficiency magnetic drums (magnetic pulleys) have enabled the beneficiation of low grade magnetite ore to discard 10% to 30% of tailings in advance, and improve the ore into the grinding grade 2-5% has played a great role in reducing the load in the grinding stage, improving the grinding efficiency, and
Jan 01, 2015· An implementation of two-step concentration (afterpurification) allowed increasing the iron content in the concentrate up to 48.2%. It forces to upgrade the process of dry magnetic separation or carry it out in the liquid phase (so-called, wet separation). Fig. 5 shows the iron ore after the process of magnetic separation.Cited by: 7
Oct 04, 2018· Low intensity techniques are normally used on magnetite ore as an inexpensive and effective separation method. High intensity separators employ fields as strong as 1 Tesla to 2 Tesla. This method is used to separate weakly magnetic iron ores such as hematite, from non-magnetic or less magnetic gangue materials.
Magnetic Separation is one of the physical concentration processes that utilizes the differences in magnetic properties of various minerals present in the ore body. The magnetic fraction may be valuable or gangue depending upon its end use in a particular process and so also the non-magnetic fraction, e.g., separation of magnetite (magnetic)